MM Firefly Grip Panel set

The MM Firefly Grip Panel Set is a 3D printed upgrade that bolts onto the Firefly's pump grip, adding a slight width increase and a noticeably better ergonomic grip texture over the stock pump grip surface. The main point of it is control during priming — with the panels fitted, the pump grip is far less likely to slip out of your hand mid-stroke, which matters more than it sounds like once you're pumping fast.

Each set comes with 2x M3 nuts and 4x M3*10 screws for installation. To fit them, drop the M3 nuts into the hex holes on the panels, line the panel holes up with the holes already on the pump grip, then drive the screws in slowly — going too fast risks stripping the screw heads or the threads. It's available in Black and Orange.