MM Firefly Shell Lifter Ramp and Low Drag Hi-Vis Follower

The new 3D printed shell lifter and hi-vis follower for the Firefly.

The new Mag tube follower and Shell lifter ramp solves all prior issues of the stock mag tube follower, where sometimes it can get stuck due to excessive friction after the last shell is ejected from the magazine tube. It has a improved diameter and surface for smoother sliding action within the magazine tube. Bright color will assist the user loading the shell into the tube at low light condition.

The Shell Lifter Ramp properly guides the firefly dart shells into the mag tube. It allows users to load the shells without worrying about the orientation of the dart shell. Users can now load the firefly dart shells more consistently in the heat of the game without looking at the loading port.

Double or Quad loads can now be done easier.

To install the shell lifter ramp correctly, Prime the blaster to allow the shell lifter to be sticking out of the blaster. Place the ramp close to the receiver shell, leaving a small space in between them. Kindly use Super glue or double side tape to ensure the Ramp holds onto the shell lifter properly. Usage of 2-part epoxy glue is ONLY recommended if you wish to make the placement of the ramp permanent, although not entirely necessary.

Colour: Orange ONLY